Frequency
Control |
Frequency Control Range |
1~120 Hz |
| Frequency Setting Resolution |
Digital: 0.01 Hz (0~99.9Hz):
1 Hz (100~120Hz)
Analog 0.06Hz/60Hz |
| Keypad Setting Method |
Direct use key for setting
 |
| Frequency Setting Signal |
0~10V, 0~20mA |
| Frequency limit |
Frequency upper / lower
limit |
Control
Characteristics |
Carry frequency |
1~8 kHz |
| Accel / Decel Time |
0.1~999 Seconds |
| V/F pattern |
6 patterns |
| Torque Control |
Torque level adjustable
(Manual torque boost) |
| Multifunction inputs |
2 input contacts of the
following signals available to select: Speed 1 command,
Jog operation, Emergency stop, External Base block, Reset
command |
| Multifunction outputs |
1 NO output contact of
the following signals available to select: During fault,
running output, agreed frequency |
| Approx. Braking torque |
20% (Braking resistor
cannot be mounted) |
| Built-in Function |
Deceleration or Free run
to stop, Auto reset, DC injection frequency/time/level
constant select |
| Digital operator monitor |
3-digit 7 segment display
frequency/function constants/fault history/CPU version |
| Ambient temperature |
-10~40°C |
| Humidity |
0~95% RH non-condensing |
| Vibration |
Under 0.5 G |
| EMC Specifications |
Class A (Filter built-in
Unifiltered) |
| Enclosure |
IP20 |
| UL |
UL 508 |
Protective
Functions |
Overload |
150% per 1 min. |
| Over-voltage |
DC bus exceeds 410V |
| Under-voltage |
DC bus drop below 200V |
| Momentary Power Loss |
0~2 sec: Inverter can
be restarted by speed search |
| Stall prevention |
During Acceleration/Deceleration/Constant
speed |
| Output short circuit |
Provided by electronic
circuit |
| Ground fault |
Provided by electronic
circuit |
| Other Protection |
Heat sink fin overheat,
current limit |
| Dimension |
L*A*P=72 mm* 130 mm* 113
mm |
| Mounting dimension |
L*A=62 mm* 115 mm |
| Installation |
Direct installation or
using DIN rail (Option) |
